Your furnace is a key part of your home. Without one, you wouldn’t be able to keep warm during cold weather. Yet furnaces can have some problems that are more typical than others.

Let’s go over these issues and discuss what they might cost to correct so you know before you contact an HVAC technician. Some of the most common furnace repair problems involve:

  • Furnace won’t turn on
  • Furnace doesn’t stay lit
  • Furnace won’t blow hot air
  • Furnace won’t turn off

1. The Furnace Won’t Turn On

There are a few reasons why your furnace won’t turn on, so make sure to check all of them.

  • Is your thermostat set correctly? Make sure it’s set to “heat,” “auto” and that your desired temperature is greater than the room’s current temperature. If you use a programmable thermostat, make sure it has new batteries.
  • Is the circuit breaker tripped? Your furnace can’t operate if it doesn’t have electricity. Reset the switch if it’s facing the outside of the electrical panel.
  • Is the furnace switch off? Your furnace has a power switch found on or close to it. Since this switch looks like a light switch, it’s easy to unintentionally turn it off. If it was off, it might take your furnace a few minutes to turn on.
  • Is the air filter clean? A dirty air filter can cause a lot of issues for your furnace. Get a new one if you can’t see light through it.

Estimated Repair Cost

This issue can be complex, so the estimated cost to repair it depends on what’s wrong.

2. The Furnace Won’t Stay Lit

Your furnace uses a certain sequence when it begins heating your home.

  1. Your thermostat detects the temperature has fallen and tells your furnace to start running.
  2. The draft inducer fan activates to bring in fresh air for combustion.
  3. The gas valve opens for the burners, which are ignited electronically.
  4. The flame sensor signals to your furnace the burners have been ignited.

If something is off during the sequence, your furnace will shut off as a safety precaution.

A couple of possible causes for this issue include:

  • Dirty or malfunctioning flame sensor. If the sensor doesn’t detect a flame, it will shut off your furnace to prevent natural gas from getting into your home. The ignition process corrodes flame sensors over time. While cleaning during annual furnace maintenance can help, yours may eventually need to be replaced.
  • Bad limit switch. This safety feature will turn off your furnace if it detects backdrafting. Backdrafting is hazardous, because carbon monoxide and natural gas can seep into your home. These switches can fail due to age, damage or dust accumulation.
  • Old thermostat. If your thermostat isn’t working properly, your furnace won’t be able to run.
  • Dirty air filter. A dirty air filter can limit airflow and cause your furnace to shut off to prevent overheating. Make sure to change yours every 30 to 90 days, or anytime you can’t see light through it.

Estimated Repair Cost

These costs are estimates, so it’s necessary to note yours may fluctuate based on your furnace’s brand and model.

  • Flame sensor: $350–$500
  • Limit switch: $150–$300
  • Thermostat: $150–$350
  • Furnace filter: $10-$30

3. My Furnace Is Blowing Cold Air

In many cases, this problem is linked to an incorrect thermostat setting or a dirty air filter that’s limiting airflow. Follow the steps above to resolve the issue.

4. My Furnace Can’t Stop Running

If it’s extremely chilly outside or you like your home to be warm, your furnace may be working for a long time.

If this isn’t the case, ensure your thermostat is set correctly and working properly. If your fan setting is at “on,” the blower motor will be going even when the furnace isn’t, so it’ll sound like your furnace is running all the time.

Alternatively, there might be a problem with the blower motor or your ductwork may be leaking air, forcing your furnace to run continuously to make up for the air loss.

Estimated Repair Cost

These costs are approximations, so it’s important to note yours may vary based on your furnace’s brand and model.

  • New blower motor: $250–$800
  • Seal ductwork: varies based on square footage

Marios Air Conditioning Will Work Hard to Resolve Your Furnace Problems as Soon as Possible

Furnace problems can be a costly headache, but not when you work with Marios Air Conditioning. We’ve been providing the quality, affordable furnace repair Thousand Palms homeowners have relied on since year. Call us at 760-314-4766 to receive your free estimate today.